After your print finishes the part will be coated with uncured resin. Give the resin some time to drip down into the vat. When most of the uncured resin has dripped off remove the build platform and transfer it to the post-processing station in the wash sink.
Carefully remove the part from the build table. BE VERY CAREFUL WHEN REMOVING THE PART TO NOT GOUGE THE ALUMINUM BUILD PLATE.
Carefully transfer the part to the alcohol bath. Avoid dripping uncured resin outside the wash sink. Rinse the part in alcohol with mild agitation for about one minute. Let the part sit in the alcohol bath for 10 minutes. Transfer to the second alcohol bath and repeat.
Remove the part from the final alcohol bath, pat dry, and dispose of the paper towels in the waste bin.
Place the washed and dried part into the UV cabinet and set the post-cure for 30 minutes or more. Formlabs published a very informative post on the importance of heat and light exposure times for post-curing resin.
Wait for the UV lamp to turn off, or turn it off manually and remove your fully cured part.